Deploy a Recovery Safe

This guide will walk you through recreating a Safe with the same address on the desired network if you send funds to your Safe address in an incorrect chain.

Recreate Safe 1.3.0 or 1.1.1

To recreate a Safe (version 1.3.0 or 1.1.1), you'll need the following essential data:

• The Singleton address
• The ProxyFactory address
• The FallbackHandler address
• The Owners addresses with which Safe was created
• The SaltNonce value
• The Threshold value
• RPC node provider for the target chain.
• The private-key of the deployer address

The necessary addresses can be collected from safe-deployments (opens in a new tab) and the salt nonce from the Safe creation transaction in a block explorer.

To recreate the Safe, it is necessary to execute the safe-creator as follows:

The Safe should have been successfully recreated with the same address on the target chain. If not, double-check the data collected from the transaction and ensure that all the necessary contracts are deployed in the chain.

Migrate a Safe from non-L2 to L2

Our services cannot index if you've recreated a Safe from an L1 network (like mainnet) on an L2 network. That's because for L1, we use trace-based indexing, and for L2 events indexing, L1 Safe singleton does not emit events.

To address this, you'll need to update it to the L2 singleton with the command update_to_l2 or consider transferring the funds to a new Safe on L2 that you control with the drain command. For detailed instructions on running these commands, please refer to the common commands section for more information.